Op Amps

Op Amps, short for Operational Amplifiers, are semiconductor devices commonly used in analogue electronic circuits. They work by receiving an input signal and amplifying it into a stronger output signal. Op Amps offer a very high voltage gain amplifiers. How do Op Amps work?Op Amps provide mathematical operations such as addition, multiplication, differentiation, and integration. They are voltage amplifiers which usually have a differential input and a single-ended output. There are two inputs into an Operational Amplifier which are called inverting (-) and non-inverting (+) inputs. If you were to increase the voltage to the inverting input, the output voltage decreases. Alternatively, if you increase the voltage to the non-inverting input, the output voltage increases. If an equal voltage is supplied to both inputs, the output will not change. What is a differential amplifier?Op Amps are often referred to as differential amplifiers. This is because the output of an Op-Amp is relative to the difference between the input voltages. Where are Op Amps used?Operational amplifiers have a wide variety of uses in electronic circuits. Here are some examples of how they are used:Crystal oscillators and waveform generatorsAudio- and video-frequency pre-amplifiers and buffersIntegratorsComparatorsAnalogue-to-digital (ADC) and digital-to-analogue (DAC) convertersVoltage ClampsAnalogue CalculatorsFiltersDifferentiatorsPrecision rectifiersLinear voltage regulatorsCurrent regulatorsPrecision rectifiersPrecision peak to peak detectors

...
Read more Read less

Filters

Viewing 1 - 1 of 1 products
Results per page
Description Price
RS Stock No. 178-2307
Mfr. Part No.NJM2734D
kr 14,157
Each (In a Tube of 50)
Units
Related Products
The Volkel Go ring gauge M4x0.7 is calibrated ...
Description:
The Volkel Go ring gauge M4x0.7 is calibrated at a measurement laboratory using IAC thread scanners. It is possible to manually screw into the entire thread of the part without using excessive force. The reference temperature for part and gauges ...
The Volkel No-Go ring gauge M12x1.75 is calibrated ...
Description:
The Volkel No-Go ring gauge M12x1.75 is calibrated at a measurement laboratory using IAC thread scanners. This No-Go thread gauge is marked in red. It must not screw into the part by hand by more than two threads. The reference ...
The Volkel Go ring gauge M6x1 is calibrated ...
Description:
The Volkel Go ring gauge M6x1 is calibrated at a measurement laboratory using IAC thread scanners. It is possible to manually screw into the entire thread of the part without using excessive force. The reference temperature for part and gauges ...
The Volkel No-Go ring gauge M3x0.5 is calibrated ...
Description:
The Volkel No-Go ring gauge M3x0.5 is calibrated at a measurement laboratory using IAC thread scanners. This NO-GO thread gauge is marked in red. It must not screw into the part by hand by more than two threads. The reference ...