Broadcom SP000063855 5 MBd 700 nm Fibre Optic Receiver, Round, Push In Collet Connector

This Fibre optic receiver converts optical signals into TTL electrical outputs for use in electronic assemblies. It is intended for through-hole mounting and is suitable where a Compact optical-to-digital Interface is required. The device is optimised for operation around a visible near-red Wavelength and supports moderate data-rate transmission for control and detection tasks.

• TTL output simplifies direct digital interfacing
• Peak sensitivity at 700nm for near-red detection
• Typical rise time 14ns for Rapid signal acquisition
• Typical fall time 4ns for fast signal clearance
• Maximum data rate 5MBd for moderate-speed links
• Five-pin configuration enables straightforward connectivity

• Suitable for inline optical-to-digital sensor modules
• Ideal for control signalling in automation systems
• Used with optical transmitters operating near 700nm
• Can be used for short-range serial optical links
• Suitable for PCB-mounted detection in equipment panels

It is designed for through-hole mounting to secure it to a PCB.

A round connector with a push-in collet secures the Fibre end for alignment.

The device uses a five-pin electrical Interface for power and signal lines.

The detector produces a TTL-compatible digital output signal.

The receiver presents a low-profile height suitable for constrained vertical spaces.