CRC 400 ml Alcohol Mould Remover Plastic, Rubber 50°C

Highly effective and powerful solvent blend developed for use on heavily soiled moulds and dies to remove a variety of moulding deposits.

Foaming action which clings to the mould surface and facilitates a good contact with the contamination.
Removes: plastics, rubbers and resin residues, even when carbonized.
Thixotropic formulation for maximum efficiency, even on vertical surfaces.
Leaves a clean and dry surface after application.

Thorough cleaning of mould surfaces.
Eliminate remnants of polymers gaskets or gaz blowouts on transforming moulds.

Apply think layer from 25 cm distance.
Allow to act on the surface for 10 to 15 minutes.
Take of the residue with a brush, plastic spatula or a water jet.
Clean the mould according to the standard procedure.
Protect the surfaces against corrosion when stored.