The Keil MCB2370 Evaluation Board provides an introduction to the NXP LPC2378 ARM microcontroller.
Standard connectors for USB 2.0 DB9 connectors for both of the LPC23xx serial ports DB9 connectors for CAN communication RJ-45 connector for Ethernet communication 2-line by 16-character LCD display. Can show real-time debug and program status messages LF Amplifier connects the DAC output of the LPC23xx device to a speaker Adjustable analogue voltage source for testing the Analog to Digital output feature of the LPC23xx JTAG interface coupled with the ULINK USB-JTAG adapter allows Flash programming The on-chip debug interface can perform real-time in-circuit emulation
Note
To run the Keil debugger using JTAG emulation, you need a ULINK USB-JTAG Adapter and two USB cables. To program the MCB2300 using the Flash Magic Utility, you need a serial cable, 9-pin male to 9-pin female, no longer than 10ft/3m, wired one-to-one.
Supplied with
μVision IDE Quick Start Guide, ARM Development Tools Overview, RealView MDK-ARM Evaluation Tools
